dbo:abstract
|
- The Fender Reverb Unit (6G15) was a vacuum tube, spring reverb-equipped effects unit made by Fender. The Reverb Unit was originally introduced in 1961. It was discontinued in 1966 and was replaced by a solid-state model, the FR1000. The unit features three controls: Dwell, Mixer and Tone and includes a 12AT7 tube as a preamplifier; a 6K6 tube as the reverb driver; and a 12AX7 as the reverb recovery tube. The rectifier is a diode-type solid state unit. The circuit board, like Fender's Brownface, Blackface and Silverface amplifiers is an eyelet board and the unit its completely hand wired. The spring reverb “tank” is mounted on the interior side of the front baffle in a vertical position. Tanks were supplied by Gibbs and Accutronics in the original version. The vertically mounted tank should be a 4AB3C1C (last letter in Accutronics model designation indicates tank orientation) but most actually shipped with 4AB3C1B tanks which are designed for horizontal mounting; these are the same ones found in the Fender combo amps where it is mounted on the floor in a horizontal configuration. Physically, the unit looks like a small amplifier head and since the early 1960s the unit has become synonymous with surf music. (en)
|
dbo:wikiPageID
| |
dbo:wikiPageLength
|
- 3102 (xsd:nonNegativeInteger)
|
dbo:wikiPageRevisionID
| |
dbo:wikiPageWikiLink
| |
dbp:wikiPageUsesTemplate
| |
dcterms:subject
| |
gold:hypernym
| |
rdf:type
| |
rdfs:comment
|
- The Fender Reverb Unit (6G15) was a vacuum tube, spring reverb-equipped effects unit made by Fender. The Reverb Unit was originally introduced in 1961. It was discontinued in 1966 and was replaced by a solid-state model, the FR1000. The unit features three controls: Dwell, Mixer and Tone and includes a 12AT7 tube as a preamplifier; a 6K6 tube as the reverb driver; and a 12AX7 as the reverb recovery tube. The rectifier is a diode-type solid state unit. The circuit board, like Fender's Brownface, Blackface and Silverface amplifiers is an eyelet board and the unit its completely hand wired. The spring reverb “tank” is mounted on the interior side of the front baffle in a vertical position. Tanks were supplied by Gibbs and Accutronics in the original version. The vertically mounted tank should (en)
|
rdfs:label
| |
owl:sameAs
| |
prov:wasDerivedFrom
| |
foaf:isPrimaryTopicOf
| |
is dbo:wikiPageWikiLink
of | |
is foaf:primaryTopic
of | |